Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

16.06.2025 00:23

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

a photo is worth a thousand words.

the problem then depends on "how fast does the fuse operate?".

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

Stephen A. Smith Responds to Viral Solitaire Photo from NBA Finals Game 4 - Bleacher Report

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

These devices are installed between the “hot” and “neutral” and protective ground.

For this case there are devices called Metal oxide varistors (MOV).

Why are men ridiculously delusional in the women they want/approach? I'm not a troll. This is a real question. Why does a fat, pot bellied, unkempt, balding, stupid (ergo poor) man, tell a woman above his league that she isn't hot enough for him?

This is the picture of an electronic coil of wire wound around a core of magnetic material.

The third is lightning and “how it gets conducted into a home.”

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

Pure Orwell: Europe condemns Iran for attacks on its own territory - Responsible Statecraft

At one ohm, the resistor has a maximum of 1 watt power.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

He then asserts :

I am 11 years old and I think I am going through puberty. Why do my nipples hurt when I touch them? Is it normal?

A circuit breaker is similar, but is resettable.

What does a fuse do?

Can the fuse protect the electronic devices from lightning instead of a surge protector.

Rainbow Six Siege X Review in Progress - IGN

He then describes the function of a fuse.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

Because the load is inductive, the current lags the voltage.(by a bit).

How do I get a white man for a serious relationship?

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

This one hit behind the barn.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

How common is it for siblings to fight over their parents' inheritance money? What is the best way to handle this type of situation?

This is 'the assistant's answer'

Now when you have a certain ac resistance, then a current flows in a loop.

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

Why would Joseph Smith say that polygamy was God's law?

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

Edit 2024–10.

Here is a simplified AC power diagram.

Why does my iPhone keep on saying I can’t upload photos to iCloud and say it doesn't have enough iCloud storage when it still has space?

There are three different concepts here that are getting confused.

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

What is lightning?

Why did McLaren hope that the Ferrari pair would pit twice during the Italian Grand Prix?

The MOV will conduct when the voltage exceeds 50% of line voltage.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

2024–10–10[John johnson John Johnson ]

Why are people so rude to debt collector’s? I am one and I am so tired of being mistreated. We are under paid and then have to deal with the most ungrateful, and disrespectful people. We aren’t customer service. Don’t get mad at us because YOU owe.

So, the voltage could go up to 500 volts, and the fuse will not open up.

(Dc diagram shown, AC is similar).

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

Is the Trump-Zelenskyy meeting a preview of what the US is going to do to Taiwan?

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

But… the neutral is now “floating” because of the 1 ohm resistance.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

Why does my mother care about my sister more than me?

[image of Common-mode choke]

An AC voltage/ current source, and an ac inductive load.

There are two important concepts here.

My blog is new. I need 10 article posts for my blog. How much should I pay for it?

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

But it can get overloaded, and no longer works.

How was your JEE 2024 result like?

This is where this question deviates from being a 'generic' question, and becomes more specific.

what exactly is a ‘surge’ protector?

nine

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

This device then solves the entire problem.

First Sentence:

2024–10–16 [ OO OLAOYE OYEBODE ]

He then describes Rainy Season and Lightning.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

In schematic diagrams this is the symbol for a fuse:

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

It seems Mohan does not understand the difference between a comment and an Answer.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

eight

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

One is “what exactly is in a ‘surge protector’ ? ”

The bolt then partially travels down the line to your home.

I post the exact comment here.

so, what happens?

One

It also is a device that limits the change in current flow.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

The other is “what does a “fuse” do?”

Barnstars:

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

This is where the MOV conducts again, and dissipated the energy.

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

These are simplified answers to the original question, and does not change anything I wrote above.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

A fuse is a non-resetable over current circuit protector.

Upvotes:

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

but I think this circuit , shows a few more pieces.

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

2024–10–14 [Omar Gharbi Omar Gharbi ]

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

At least they know the answer if they wanted it.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

[old diagram got deleted by accident]

but this device (an Inductor) … impedes the rapid changes in the current.